The Ledco H20 Dual Hot Roll Industrial Laminator is an evolution in heavy-duty laminators. This 20" wide heated roller laminator is user friendly for applications including laminating, mounting and encapsulation in one pass up to 1/2 inch thick. Manufactured in the U.S. it comes with a 2 year factory warranty.
For commercial users that need the highest quality of finished lamination, The H20 laminator has variable speed up to 10 feet per minute, digital temperature controls, inline slitters, and forced air cooling. The rubber rolls are spring loaded and preset for even laminating pressure. A reverse switch on motor and pressure release controls make it easier to clear film in case of an error.
The H20 has the infared sensor that reads the surface temperature of the rolls. It reads the roll temperature after the film has been laminated, and provides a more accurate temperature sensor reading. It will laminate 1.5 mil up to 10 mil thick films.
Features & Benefits:
Variable speed. The laminator operates at any speed up to 10 feet / 3 meters per minute. Thicker hot films are generally applied better at mid-range to lower speeds, while 1.5 mil hot films should be applied at mid-range to higher speeds.
Lamination pressure. The rubber rollers are spring-loaded and preset to ensure correct and even lamination pressure. The pressure is easy to adjust if required when performing routine maintenance.
Precision Heat Controls. Individual top and bottom heat controls, as used on our other Digital Laminators, allow for even, consistent heating of the laminating rollers throughout the entire temperature range.
Ease of cleaning. The heated silicone rubber laminating rollers, and the silicone rubber pull rollers of the laminator should be cleaned regularly. The safety shield on the laminator swings away in seconds, making it easy to clean the laminating rollers.
Supply roll tension controls. Supply roll tension is easy to adjust by simply tightening or loosening the tension control knobs on the supply roll mandrels.
Attached safety shield. The polycarbonate shield is clear so operators can see their work. It does not conduct heat so they’ll be protected from hot areas. It is fixed to the laminator and the machine will not run if the feed tray and safety shield are not in place.
Feed tray pressure strip. This strip on the front of the feed tray holds images flat as they go into the laminator, making it easier to handle the lightweight papers sometimes used in digital imaging.
Ease of maintenance. The H20 laminator is made to last. However, some items on a laminator do wear out. Even the high-quality silicone rubber used in the rollers will lose flexibility over time. Extensive use may wear out the rollers, or an operator may cut a roller by accident. Rollers and other key parts can be changed quickly without disassembling the frame.
Standard Features Include: precision feed table, slitter assembly, and stand with casters